x10 Automation and the cm15a

Haven't played with misterhouse for a while and since the last time we did, we upgraded the kernel on our freevo misterhouse media box.

Tried to turn on a light for a while and released that as we're using the usb cm15a as our pc interface, I needed to rebuild the module. Look at my last blog notes and found that they really weren't detailed enough for me to remember how it all worked. Bad bristley - should take better notes.

Searching google based on the sparse clues I'd left myself I found this useful post on the cm15a with the generic usb driver.

So a synopsis in case it disappears or I'm too lazy to look it up next time.

Doing cat /proc/bus/usb/devices shows me that I have the x10 usb device there but no driver.

T: Bus=01 Lev=01 Prnt=01 Port=01 Cnt=02 Dev#= 4 Spd=1.5 MxCh= 0
D: Ver= 1.10 Cls=00(>ifc ) Sub=00 Prot=00 MxPS= 8 #Cfgs= 1
P: Vendor=0bc7 ProdID=0001 Rev= 1.00
S: Manufacturer=X10 Wireless Technology Inc
S: Product=USB ActiveHome Interface
C:* #Ifs= 1 Cfg#= 1 Atr=c0 MxPwr= 2mA
I:* If#= 0 Alt= 0 #EPs= 2 Cls=00(>ifc ) Sub=00 Prot=00 Driver=(none)
E: Ad=81(I) Atr=03(Int.) MxPS= 8 Ivl=10ms
E: Ad=02(O) Atr=03(Int.) MxPS= 8 Ivl=10ms

I already had the iplc driver code from this page sitting in my home directory from last time. I had already modified the code to work with the latest 2.6 kernels as recommended on the instruction page. I installed the kernel headers and kernel source (apt-get - I love Debian).

Then I built the cm15a driver - this is the bit I'd forgotten. I tried make -f Makefile.cm15a but what you're supposed to do is

make cm15a

This built the driver for me in /root/iplc/driver/linux-2.6/cm15a.d/cm15a.ko
From the cm15a.d directory I ran

insmod cm15a.ko

And then my at cat /proc/bus/usb/devices showed

T: Bus=01 Lev=01 Prnt=01 Port=01 Cnt=02 Dev#= 4 Spd=1.5 MxCh= 0
D: Ver= 1.10 Cls=00(>ifc ) Sub=00 Prot=00 MxPS= 8 #Cfgs= 1
P: Vendor=0bc7 ProdID=0001 Rev= 1.00
S: Manufacturer=X10 Wireless Technology Inc
S: Product=USB ActiveHome Interface
C:* #Ifs= 1 Cfg#= 1 Atr=c0 MxPwr= 2mA
I:* If#= 0 Alt= 0 #EPs= 2 Cls=00(>ifc ) Sub=00 Prot=00 Driver=cm15a
E: Ad=81(I) Atr=03(Int.) MxPS= 8 Ivl=10ms
E: Ad=02(O) Atr=03(Int.) MxPS= 8 Ivl=10ms

Note that Driver on the I line now says cm15a. And there is now a /dev/cm15a0 device.